Wide 5/ 5x5 Hubholder

Designed and fabricated in-house by our fab department, the Hub Holder is a vise-mounted fixture that locks a wheel hub in place so rotors can be serviced quickly and safely. Drop the hub into the holder, clamp it in your bench vise, and the hub sits rock-steady — freeing both hands to swap, seat, and torque rotors without fighting the assembly or risking damage to the bearing/stud lineup.

Two versions are available to match your wheel bolt pattern:

• Wide 5 Hub Holder — for Wide 5 (5x5.5" / 5x139.7) hubs.
• Standard Hub Holder — fits 4.5" and 5x5 (5x127) bolt pattern hubs.

Features

• Vise-mounted — secures in any standard bench vise; no press or fixture stand required.
• Hub-locating bore — cradles the hub register so it won't spin or tilt while the rotor is off.
• Stud clearance — bolt pattern matched so wheel studs pass through without load.
• Hardened steel construction — built to take repeated torquing and impact use in a shop environment.
• Compact footprint — stores in a toolbox drawer when not in use.

Built for our shop, by our shop — a simple, rugged tool that turns a two-person, pry-bar job into a one-person, ten-minute job.